[gui-talk] duxbury

[denise avant]

Okay, so what is needed to make sure the escape sequences are acting
properly.
Because what you have described is what is happening.
 

-----Original Message-----
From: gui-talk-bounces at nfbnet.org [mailto:gui-talk-bounces at nfbnet.org] On
Behalf Of Lloyd Rasmussen
Sent: Tuesday, October 10, 2006 8:52 PM
To: 'NFBnet GUI Talk Mailing List'
Subject: Re: [gui-talk] duxbury

With the latest Duxbury versions (10.5 and 10.6) you need to make sure that
the embosser is set to act upon escape sequences.  Duxbury will send these
commands at the beginning of your file to set paper size, margins, etc., and
if the printer is not acting on them, it will print some gibberish at the
top of the file.  That might be what's happening.


Lloyd Rasmussen, Kensington, Maryland
Home:  http://lras.home.sprynet.com
Work:  http://www.loc.gov/nls
 
> -----Original Message-----
> From: gui-talk-bounces at nfbnet.org [mailto:gui-talk-bounces at nfbnet.org] 
> On Behalf Of denise avant
> Sent: Tuesday, October 10, 2006 9:19 PM
> To: NFBnet GUI Talk Mailing List
> Subject: Re: [gui-talk] duxbury
> 
> Nick,
> I am not sure what you are talking about.  I went through the embosser 
> setup in duxbury.  and that was all.  in fact that's all I've 
> generally every had to do
> 
> 

_______________________________________________
gui-talk mailing list
gui-talk at nfbnet.org
http://www.nfbnet.org/mailman/listinfo/gui-talk